Fujitsu PRIMERGY BX900 User Manual page 507

10.6.1.14 oob gateway
This command sets the IP address of the default gateway of Out-of-Band interface.
Syntax
oob gateway <gateway>
no oob gateway
< gateway > - IP address of the default gateway
no - Restore the default IP address of the default gateway
The gateway of in-band and out-of-band (oob) management interface can't be set at the
i
same time. If the gateway of oob has been set, you have to remove it before you configure
the gateway of in-band management interface.
Default Setting
Gateway Address : 0.0.0.0
Command Mode
Global Config
10.6.1.15 oob protocol
This command specifies the oob configuration protocol to be used. If you modify this value, the change is
effective immediately.
Syntax
oob protocol {bootp | dhcp | dhcp6 | none}
<bootp> - Obtains IP address from BOOTP.
<dhcp> - Obtains IP address from DHCP.
<dhcp6> - Obtains IPv6 address from DHCPv6.
<none> - Obtains IP address by setting configuration.
Both of in-band and out-of-band management interfaces could be configured to use DHCP
i
to get the IP address from DHCP server at a time, but not simultaneously.
Default Setting
DHCP
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
505