9.2.3.5
Traceroute
Use this screen to tell the switch to send a TraceRoute request to a specified IP address.You can use
this to discover the paths packets take to a remote destination. Once you click the Apply button, the
switch will send traceroute and the results will be displayed below the configurable data. If a reply to the
traceroute is you will see
1 x.y.z.w
1 ms 2 ms 3 ms
2 0.0.0.0
0 ms 0 ms 0 ms
3 0.0.0.0
0 ms 0 ms 0 ms
Figure : Traceroute
Configurable Data
IPv4 Address/Host Name/Host Name V6/IPv6 Address - Enter the address of the station you want
the switch to discover path. The initial value is blank. The address you enter is not retained across a
power cycle.
Probes Per Hop - Enter the number of probes per hop. The initial value is default. The Probes per
Hop you enter is not retained across a power cycle.
MaxTTL - Enter the maximum TTL for the destination. The initial value is default value. The MaxTTL
you enter is not retained across a power cycle.
InitTTL - Enter the initial TTL to be used. The initial value is default value. The InitTTL you enter is
not retained across a power cycle.
Interval - Enter the Time between probes in seconds. The initial value is default value. The Interval
you enter is not retained across a power cycle.
Command Buttons
Apply - This will initiate the traceroute.
2011 Fujitsu Technology Solutions
©
94