Fujitsu PRIMERGY BX900 User Manual page 230

9.3.13.2 Interface Config
Figure : MLD Snooping Interface Config
Selection Criteria
Unit/Slot/Port - The single select box lists all physical ,VLAN and LAG interfaces. Select the
interface you want to configure.
Admin Mode - Select the interface mode for the selected interface for MLD Snooping for the switch
from the pull down menu. The default is disable.
Fast Leave Admin mode - Select the Fast Leave mode for the a particular interface from the pull
down menu. The default is disable.
Configurable Data
Group Membership Interval - Specify the amount of time you want the switch to wait for a report for
a particular group on a particular interface before it deletes that interface from the group. The valid
range is from (2 to 3600) seconds. The configured value must be greater than Max Response Time.
The default is 260 seconds.
Max Response Time - Specify the amount of time you want the switch to wait after sending a query
on an interface because it did not receive a report for a particular group on that interface. Enter a
value betwween 1 to 65 and less than the Group Membership Interval in seconds. The default is 10
seconds. The configured value must be less than the Group Membership Interval.
Multicast Router Present Expiration Time - Specify the amount of time you want the switch to wait
to receive a query on an interface before removing it from the list of interfaces with multicast routers
attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of zero
indicates an infinite timeout, i.e. no expiration.
Command Buttons
Apply - Update the switch with the values you entered. If you want the switch to retain the new
values across a power cycle you must perform a save. You will only see this button if you have
Read/Write access privileges.
2011 Fujitsu Technology Solutions
©
228