Fujitsu PRIMERGY BX900 User Manual page 215

9.3.9.2 Interface Config
Figure : IGMP Snooping Interface Config
Selection Criteria
Unit/Slot/Port - The single select box lists all physical ,VLAN and LAG interfaces. Select the
interface you want to configure.
Admin Mode - Select the interface mode for the selected interface for IGMP Snooping for the switch
from the pull down menu. The default is disable.
Fast Leave Admin mode - Select the Fast Leave mode for the a particular interface from the pull
down menu. The default is disable.
Configurable Data
Group Membership Interval - Specify the amount of time you want the switch to wait for a report for
a particular group on a particular interface before it deletes that interface from the group. Enter a
value between 1 and 3600 seconds. The default is 260 seconds.
Max Response Time - Specify the amount of time you want the switch to wait after sending a query
on an interface because it did not receive a report for a particular group on that interface. Enter a
value between 1 to 25 and less than the Group Membership Interval in seconds. The default is 10
seconds. The configured value must be less than the Group Membership Interval.
Multicast Router Present Expiration Time - Specify the amount of time you want the switch to wait
to receive a query on an interface before removing it from the list of interfaces with multicast routers
attached. Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of zero
indicates an infinite timeout, i.e. no expiration.
Command Buttons
Apply - Update the switch with the values you entered. If you want the switch to retain the new
values across a power cycle you must perform a save. You will only see this button if you have
Read/Write access privileges.
2011 Fujitsu Technology Solutions
©
213