Fujitsu PRIMERGY BX900 User Manual page 409

10.4.3.19 switchport tagging
This command configures the tagging behavior for a specific interface in a VLAN to enable. If tagging is
enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged
frames. The ID is a valid VLAN identification number.
Syntax
switchport tagging <vlanid>
no switchport tagging <vlanid>
<vlanid> - VLAN ID (Range: 1 - 4094).
no - This command configures the tagging behavior for a specific interface in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
The range of VLAN ID is 1 to 4093 for the stackable connection blade.
i
In EHM, with the uplink VLAN synchronization is enabled, it will not change the tagging of
!
the native VLAN ID on uplinks. All VLAN Ids except the native VLAN ID will be changed to
tagging while the uplink VLAN synchronization is enabled.
Default Setting
Disabled
Command Mode
Interface Config
2011 Fujitsu Technology Solutions
©
407