Fujitsu PRIMERGY BX900 User Manual page 574

10.6.15.6 cdp run
This command is used to enable CDP on a specified interface.
Syntax
cdp run
no cdp run
no - This command is used to disable CDP on a specified interface.
Default Setting
Enabled
Command Mode
Interface Config
This command is used to enable CDP for all interfaces.
Syntax
cdp run all
no cdp run all
all - All interfaces.
no - This command is used to disable CDP for all interfaces.
Default Setting
Enabled
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
572