10.10.2.7 spanning-tree uplinkfast
This command sets the Uplink Fast parameter to a new value on this switch. This command only works on
dot1d mode.
Syntax
spanning-tree uplinkfast
no spanning-tree uplinkfast
no - This command sets the Uplink Fast parameter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Global Config
10.10.2.8 spanning-tree loopguard
This command sets the Loop Guard parameter to a new value on this switch. This command only works on
dot1d mode.
Syntax
spanning-tree loopguard
no spanning-tree loopguard
no - This command sets the Force Protocol Version parameter to the default value, that is Disabled.
Default Setting
Disabled
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
657