Fujitsu PRIMERGY BX900 User Manual page 505

10.6.1.11 ip filter
This command is used to set an IPv4/IPv6 address to be a filter.
Syntax
ip filter <name> ipv4 <ipAddr> [<mask>]
no ip filter <name>
<name> - The name of the ip filter.
<ipAddr> - Configure a IPv4 address to be filtered.
<mask> - Configure a IPv4 netmask to be filtered.
no - Remove a filter by filter name.
Default Setting
None
Command Mode
Global Config
Syntax
ip filter < name> ipv6 <prefix/length>
no ip filter < name>
<name> - The name of the ip filter.
<prefix/length> - Configure a IPv6 prefix and prefix length to be a filter.
no - Remove ip filter by filter name
Default Setting
None
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
503