10.9.12
reload
This command resets the switch without powering it off. Reset means that all network connections are
terminated and the boot code executes. The switch uses the stored configuration to initialize the switch.
You are prompted to confirm that the reset should proceed. A successful reset is indicated by the LEDs on
the switch.
Syntax
reload [slot <unit>]
(*)slot - Reload stack or a switch in the stack.
(*)<unit> - switch ID in the range of 1 to 8 or CB name.
Note: (*) is the stacking commands.
Default Setting
None
Command Mode
Privileged Exec
10.9.13
configure
This command is used to activate global configuration mode
Syntax
configure
Default Setting
None
Command Mode
Privileged Exec
2011 Fujitsu Technology Solutions
©
637