Fujitsu PRIMERGY BX900 User Manual page 779

10.18.2.4 mac access-group in
This command attaches a specific MAC Access Control List (ACL) identified by <name> to an interface in
a given direction. The <name> parameter must be the name of an exsiting MAC ACL. An optional
sequence number may be specified to indicate the order of this access list relative to other access lists
already assigned to this interface and direction. A lower number indicates higher precedence order. If a
sequence number is already in use for this interface and direction, the specified access list replaces the
currently attached access list using that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence number currently in use for
this interface and direction will be used. This command specified in 'Interface Config' mode only affects a
single interface, whereas the 'Global Config' mode setting is applied to all interfaces. The 'Interface Config'
mode command is only available on platforms that support independent per-port class of service queue
configuration.
Syntax
mac access-group <name> in [<1-4294967295>]
no mac access-group <name> in
<name> - It uniquely identifies the MAC access list.
<1-4294967295> - The sequence number of this ACL.
no - This command removes a MAC ACL identified by <name> from the interface in a given direction.
Default Setting
None
Command Mode
Global Config, Interface Config
2011 Fujitsu Technology Solutions
©
777