Fujitsu PRIMERGY BX900 User Manual page 133

9.2.8.3 SNMP EngineID Config
This menu will display an entry for configuring remote Engine ID.
Figure : SNMP EngineID Config
Selection Criteria
Protocol - Select IPv4 or IPv6 to configure the corresponding attributes.
IP Address - You can use this screen to reconfigure an existing host, or to create a new one. Use
this pulldown menu to select one of the existing host, or select 'Create' to add a new one.
Configurable Data
IP Address - Enter the IP address of SNMP host which will receive SNMP trap/inform from this
switch. Enter 4 numbers between 0 and 255 separated by periods.
Engine ID - Enter new or changed Engine ID for the selected host. The Engine ID are up to 24
hexadecimal characters in length.
Command Buttons
Apply - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete - Delete the currently selected SNMP Engine ID. If you want the switch to retain the new
values across a power cycle, you must perform a save.
2011 Fujitsu Technology Solutions
©
131