Fujitsu PRIMERGY BX900 User Manual page 532

10.6.5.9 snmp-server host
This command sets a client IP or IPv6 address for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP mask value to denote a
range of IP addresses from which SNMP clients may use that community to access the device. A value
of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with the mask to
determine the range of allowed client IP addresses. The name is the applicable community name.
Syntax
snmp-server host <ipaddr | ipv6Addr> <name>
No snmp-server host <name>
<name> - community name.
<ipaddr | ipv6Addr> - a client IP or IPv6 address.
no - This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Default Setting
0.0.0.0
Command Mode
Global Config
10.6.5.10 snmp-server host ipmask
This command sets a client IP mask for an SNMP community.
Syntax
snmp-server host ipmask <ipmask > <name>
No snmp-server host ipmask <name>
<name> - community name.
<ipmask> - a client IP mask.
no - This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Default Setting
0.0.0.0
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
530