Access Control Lists - Fujitsu PRIMERGY BX900 User Manual

9.4.7

Access Control Lists

9.4.7.1 IP Config
An IP ACL consists of a set of rules which are matched sequentially against a packet. When a packet
meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional
rules are not checked for a match. On this menu the interfaces to which an IP ACL applies must be
specified, as well as whether it applies to inbound or outbound traffic. Rules for the IP ACL are
specified/created using the IP ACL Rule Configuration menu.
Figure : Access Control Lists IP Config
Selection Criteria
IP ACL - Make a selection from the pull down menu. A new IP Access Control List may be created or
the configuration of an existing IP ACL can be updated.
Configurable Data
IP ACL ID - IP ACL ID must be a whole number in the range of 1 to 99 for IP Standard Access Lists
and 100 to 199 for IP Extended Access Lists.
IP ACL NAME - Specifies IP ACL Name string which includes alphanumeric characters only. The
name up to 31 characters in length. The name must start with an alphabetic character. This field
displays the name of the currently selected IP ACL if the ACL has already been created.
Non-Configurable Data
Table - Displays the current and maximum number of IP ACLs.
Current Size - The current number of IP ACLs.
Max Size – The maximum number of IP ACLs.
Command Buttons
Apply - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Delete - Removes the currently selected IP ACL from the switch configuration.
2011 Fujitsu Technology Solutions
©
303