Fujitsu PRIMERGY BX900 User Manual page 592

10.6.17.14 lldp timers
This command is used to set the timing parameters for local data transmission on ports enabled for LLDP.
The <interval-seconds> determines the number of seconds to wait between transmitting local data LLDP
frames. The range is 1-32768 seconds. The <hold-value> is the multiplier on the transmit interval that sets
the TTL in local data LLDP frames. The multiplier range is 2-10. The <reinit-seconds> is the delay before
re-initialization, and the range is 1-0 seconds.
Syntax
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-seconds>]
no lldp timers [interval] [hold] [reinit]
<interval-seconds> - Configures the number of seconds to wait between transmitting local data LLDP
frames.
<hold-value> - Configures the multiplier on the transmit interval that sets the TTL in local data LLDP
frames.
<reinit-seconds> - Configures the delay before re-initialization
no - This command is used to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Default Setting
Interval-seconds: 30
Hold-value: 4
Reinit-seconds: 2
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
590