Fujitsu PRIMERGY BX900 User Manual page 546

10.6.8.3 ip http port
This command is used to set the http port where port can be 1-65535 and the default is port 80.
Syntax
ip http port <1-65535>
no ip http port
<1-65535> - HTTP Port value.
no - This command is used to reset the http port to the default value.
Default Setting
80
Command Mode
Global Config
10.6.8.4 ip http server
This command enables access to the switch through the Web interface. When access is enabled, the
user can login to the switch from the Web interface. When access is disabled, the user cannot login to
the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are affected.
Syntax
ip http server
no ip http server
no - This command disables access to the switch through the Web interface. When access is
disabled, the user cannot login to the switch's Web server.
Default Setting
Enabled
Command Mode
Global Config
2011 Fujitsu Technology Solutions
©
544