Permit, Deny, Redirect-To (Standard Ipv6 Acl) - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

permit, deny, redirect-to (Standard IPv6 ACL)

This command adds a rule to a Standard IPv6 ACL. The rule sets a filter condition for
packets emanating from the specified source. Use the no form to remove a rule.
Syntax
{permit | deny | redirect-to interface}
{any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
[time-range time-range-name]
no {permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-52)
any – Any source IP address.
host – Keyword followed by a specific IP address.
source-ipv6-address - An IPv6 source address or network class. The address must
be formatted according to RFC 2373 "IPv6 Addressing Architecture," using 8
colon-separated 16-bit hexadecimal values. One double colon may be used in the
address to indicate the appropriate number of zeros required to fill the undefined
fields.
prefix-length - A decimal value indicating how many contiguous bits (from the left) of
the address comprise the prefix; i.e., the network portion of the address. (Range:
0-128)
time-range-name - Name of the time range.
(Range: 1-30 characters)
Default Setting
None
Command Mode
Standard IPv6 ACL
Command Usage
New rules are appended to the end of the list.
26-12