Setting The Switch's Ip Address (Ip Version 4) - Supermicro SSE-G2252 User Manual

16-3 Setting the Switch's IP Address (IP Version
4)
Use the S
YSTEM
the network. This switch supports both IPv4 and IPv6, and can be managed through
either of these address types. For information on configuring the switch with an IPv6
address, see Section 16-4: "Setting the Switch's IP Address (IP Version 6)" on
page 16-7.
You can direct the device to obtain an address from a BOOTP or DHCP server, or
manually configure a static IP address. Valid IP addresses consist of four decimal
numbers, 0 to 255, separated by periods. Anything other than this format will not be
accepted.
A static address of 192.168.100.102 is set by default for VLAN 1. To configure an
address compatible with your network, you need to change the switch's default settings.
You may also need to a establish a default gateway between the switch and
management stations that exist on another network segment.
CLI References
See Section 41-1: "DHCP Client" on page 41-1
page 42-2 for CLI reference information.
Parameters
These parameters are displayed in the web interface:
• Management VLAN – ID of the configured VLAN (1-4093). By default, all ports on
the switch are members of VLAN 1. However, the management station can be
attached to a port belonging to any VLAN, as long as that VLAN has been assigned
an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot
Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has
been received from the server. Requests will be broadcast periodically by the switch
for an IP address. DHCP/BOOTP responses can include the IP address, subnet
mask, and default gateway. (Default: Static)
Figure 16-3. Displaying ARP Entries
> IP page to configure an IPv4 address for management access over
Chapter 16: IP Configuration
and "Basic IPv4 Configuration" on
16-5