Lacp System-Priority - Supermicro SSE-G2252 User Manual

lacp system-priority

This command configures a port's LACP system priority. Use the no form to restore the
default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
priority - This priority is used to determine link aggregation group (LAG)
membership, and to identify this device to other switches during LAG negotiations.
(Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Port must be configured with the same system priority to join the same LAG.
• System priority is combined with the switch's MAC address to form the LAG
identifier. This identifier is used to indicate a specific LAG during LACP negotiations
with other systems.
• Once the remote side of a link has been established, LACP operational settings are
already in use on that side. Configuring LACP settings for the partner only applies to
its administrative state, not its operational state, and will only take effect the next
time an aggregate link is established with the partner.
Example
SSE-G2252(config)#interface ethernet 1/5
SSE-G2252(config-if)#lacp actor system-priority 3
SSE-G2252(config-if)#
Chapter 28: Link Aggregation Commands
28-7