Lacp - Supermicro SSE-G2252 User Manual

Example
The following example creates trunk 1 and then adds port 11:
SSE-G2252(config)#interface port-channel 1
SSE-G2252(config-if)#exit
SSE-G2252(config)#interface ethernet 1/11
SSE-G2252(config-if)#channel-group 1
SSE-G2252(config-if)#

lacp

This command enables 802.3ad Link Aggregation Control Protocol (LACP) for the
current interface. Use the no form to disable it.
Syntax
[no] lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• The ports on both ends of an LACP trunk must be configured for full duplex, either
by forced mode or auto-negotiation.
• A trunk formed with another switch using LACP will automatically be assigned the
next available port-channel ID.
• If the target switch has also enabled LACP on the connected ports, the trunk will be
activated automatically.
• If more than eight ports attached to the same target switch have LACP enabled, the
additional ports will be placed in standby mode, and will only be enabled if one of
the active links fails.
Chapter 28: Link Aggregation Commands
28-3