Rspan Remote Vlan - Supermicro SSE-G2252 User Manual

52-port layer 2 gigabit ethernet switch / with 48 poe-capable ports
Hide thumbs Also See for SSE-G2252:
Table of Contents

Advertisement

SSE-G2252/SSE-G2252P Switches User's Manual
Command Mode
Global Configuration
Command Usage
Only one destination port can be configured on the same switch per session, but a
destination port can be configured on more than one switch for the same session.
Only 802.1Q trunk or hybrid (i.e., general use) ports can be configured as an
RSPAN destination port – access ports are not allowed (see
Only ports can be configured as an RSPAN destination – static and dynamic trunks
are not allowed.
The source port and destination port cannot be configured on the same switch.
A destination port can still send and receive switched traffic, and participate in any
Layer 2 protocols to which it has been assigned.
Example
The following example configures port 4 to receive mirrored RSPAN traffic:
SSE-G2252(config)#rspan session 1 destination interface ethernet 1/2
SSE-G2252(config)#

rspan remote vlan

Use this command to specify the RSPAN VLAN, switch role (source, intermediate or
destination), and the uplink ports. Use the no form to disable the RSPAN on the
specified VLAN.
Syntax
[no] rspan session session-id remote vlan vlan-id
{source | intermediate | destination} uplink interface
session-id – A number identifying this RSPAN session (Range: 1-2). Only two mirror
sessions are allowed, including both local and remote mirroring. If local mirroring is
enabled with the
RSPAN.
vlan-id - ID of configured RSPAN VLAN (Range: 2-4092), Use the
command to reserve a VLAN for RSPAN mirroring before enabling RSPAN with this
command.
source - Specifies this device as the source of remotely mirrored traffic.
intermediate - Specifies this device as an intermediate switch, transparently
passing mirrored traffic from one or more sources to one or more destinations.
destination - Specifies this device as a switch configured with a destination port
which is to receive mirrored traffic for this session.
port monitor
command, then there is only one session available for
30-8
switchport
mode).
vlan rspan

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sse-g2252p

Table of Contents