Chapter 37 Quality Of Service Commands; Class-Map; Description - Supermicro SSE-G2252 User Manual

Quality of Service Commands
The commands described in this section are used to configure Differentiated Services
(DiffServ) classification criteria and service policies. You can classify traffic based on
access lists, IP Precedence or DSCP values, or VLANs. Using access lists allows you
select traffic based on Layer 2, Layer 3, or Layer 4 information contained in each packet.
Command

class-map

description

match
rename
policy-map
description
class
rename
police flow
police srtcm-color
police trtcm-color
set cos
set ip dscp
set phb
service-policy
show class-map
show policy-map
show policy-map interface
Chapter 37
Table 37-1. Quality of Service Commands
Function
Creates a class map for a type of traffic
Specifies the description of a class map
Defines the criteria used to classify traffic
Redefines the name of a class map
Creates a policy map for multiple interfaces
Specifies the description of a policy map
Defines a traffic classification for the policy to act on
Redefines the name of a policy map
Defines an enforcer for classified traffic based on a
metered flow rate
Defines an enforcer for classified traffic based on a single
rate three color meter
Defines an enforcer for classified traffic based on a two
rate three color meter
Services IP traffic by setting a class of service value for
matching packets for internal processing
Services IP traffic by setting an IP DSCP value for
matching packets for internal processing
Services IP traffic by setting a per-hop behavior value for
matching packets for internal processing
Applies a policy map defined by the
command to the input of a particular interface
Displays the QoS class maps which define matching
criteria used for classifying traffic
Displays the QoS policy maps which define classification
criteria for incoming traffic, and may include policers for
bandwidth limitations
Displays the configuration of all classes configured for all
service policies on the specified interface
Chapter 37: Quality of Service Commands
37-1
policy-map
Mode
GC
CM
CM
CM
GC
PM
PM
PM
PM-C
PM-C
PM-C
PM-C
PM-C
PM-C
IC
PE
PE
PE