Shutdown; Speed-Duplex - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

shutdown

This command disables an interface. To restart a disabled interface, use the no form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior (e.g., excessive
collisions), and then re-enable it after the problem has been resolved. You may also
want to disable a port for security reasons.
Example
The following example disables port 5.
SSE-G2252(config)#interface ethernet 1/5
SSE-G2252(config-if)#shutdown
SSE-G2252(config-if)#

speed-duplex

This command configures the speed and duplex mode of a given interface when
auto-negotiation is disabled. Use the no form to restore the default.
Syntax
speed-duplex {1000full | 100full | 100half | 10full | 10half}
no speed-duplex
1000full - Forces 1000 Mbps full-duplex operation
100full - Forces 100 Mbps full-duplex operation
100half - Forces 100 Mbps half-duplex operation
10full - Forces 10 Mbps full-duplex operation
10half - Forces 10 Mbps half-duplex operation
27-10