Queue Weight - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

queue weight

This command assigns weights to the four class of service (CoS) priority queues when
using weighted queuing, or one of the queuing modes that use a combination of strict
and weighted queuing. Use the no form to restore the default weights.
Syntax
queue weight weight0...weight3
no queue weight
weight0...weight3 - The ratio of weights for queues 0 - 3 determines the weights
used by the SWDRR scheduler. (Range: 1-15)
Default Setting
Weights 1, 2, 4, 6 are assigned to queues 0 - 3 respectively.
Command Mode
Global Configuration
Command Usage
• This command shares bandwidth at the egress port by defining scheduling weights
for SWDRR, or for the queuing mode that uses a combination of strict and weighted
queuing ("queue mode" on page
• Bandwidth is allocated to each queue by calculating a precise number of bytes per
second that will be serviced on each round.
Example
The following example shows how to assign round-robin weights of 1 - 4 to the CoS
priority queues 0 - 3.
SSE-G2252(config)#queue weight 1 2 3 4
SSE-G2252(config)#
Related Commands
"queue mode" on page 36-2
"show queue weight" on page 36-6
36-2).
36-4