Static Multicast Routing; Ip Igmp Snooping Vlan Mrouter - Supermicro SSE-G2252 User Manual

38-2 Static Multicast Routing

This section describes commands used to configure static multicast routing on the
switch.
Table 38-3. Static Multicast Interface Commands
Command

ip igmp snooping vlan mrouter

show ip igmp snooping mrouter
ip igmp snooping vlan mrouter
This command statically configures a (Layer 2) multicast router port on the specified
VLAN. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-52)
port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
• Depending on your network connections, IGMP snooping may not always be able to
locate the IGMP querier. Therefore, if the IGMP querier is a known multicast router
or switch connected over the network to an interface (port or trunk) on this switch,
that interface can be manually configured to join all the current multicast groups.
• IGMP Snooping must be enabled globally on the switch (using the
command) before a multicast router port can take effect.
Chapter 38: Multicast Filtering Commands
Function
Adds a multicast router port
Shows multicast router ports
38-25
Mode
GC
PE
ip igmp snooping