Switchport Native Vlan - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

switchport native vlan

This command configures the PVID (i.e., default VLAN ID) for a port. Use the no form to
restore the default.
Syntax
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093, no leading zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When using Access mode, and an interface is assigned to a new VLAN, its PVID is
automatically set to the identifier for that VLAN. When using Hybrid mode, the PVID
for an interface can be set to any VLAN for which it is an untagged member.
• If acceptable frame types is set to all or switchport mode is set to hybrid, the PVID
will be inserted into all untagged frames entering the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
SSE-G2252(config)#interface ethernet 1/1
SSE-G2252(config-if)#switchport native vlan 3
SSE-G2252(config-if)#
35-16