Supermicro SSE-G2252 User Manual page 1023

Field
MVR Config Status
MVR Running Status
MVR Multicast VLAN
MVR Group Address
MVR Group Count
The following displays information about the interfaces attached to the MVR VLAN:
SSE-G2252#show mvr interface
Port Type
-------- --------
Eth1/ 2 Source
Eth1/ 3 Source
Eth1/ 1 Receiver
Eth1/ 4 Receiver
SSE-G2252#
Table 38-7. show mvr interface - Display Description
Field
Port
Type
Status
Immediate Leave
Static Group Address Shows any static MVR group assigned to an interface, and the receiver VLAN.
The following shows information about the interfaces associated with multicast groups
assigned to the MVR VLAN:
SSE-G2252#show mvr members
MVR Forwarding Entry Count:1
Group Address
-------------
225.0.0.9
SSE-G2252#
Table 38-6. show mvr - Display Description
Description
Shows if MVR is globally enabled on the switch.
Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists.)
Shows the VLAN used to transport all MVR multicast traffic.
A multicast service sent to all attached subscribers
The number of contiguous MVR group addresses.
Status
-------------
Active/Up
Inactive/Down
Active/Up
Active/Down
Description
Shows interfaces attached to the MVR.
Shows the MVR port type.
Shows the MVR status and interface status. MVR status for source ports is
"ACTIVE" if MVR is globally enabled on the switch. MVR status for receiver ports
is "ACTIVE" only if there are subscribers receiving multicast traffic from one of
the MVR groups, or a multicast group has been statically assigned to an
interface.
Shows if immediate leave is enabled or disabled.
Source Address
--------------
*
Chapter 38: Multicast Filtering Commands
Immediate
---------
Disabled
Disabled
VLAN Forwarding Port
---- --------------
2 Eth1/ 1(VLAN3)
38-41
Static Group Address
--------------------
225.0.0.1(VLAN1)
225.0.0.9(VLAN3)
Eth1/ 2(VLAN2)