Permit, Deny, Redirect-To (Mac Acl) - Supermicro SSE-G2252 User Manual

permit, deny, redirect-to (MAC ACL)

This command adds a rule to a MAC ACL. The rule filters packets matching a specified
MAC source or destination address (i.e., physical layer address), or Ethernet protocol
type. Use the no form to remove a rule.
Syntax
{permit | deny | redirect-to interface}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]] [time-range
time-range-name]
no {permit | deny | redirect-to interface}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
NOTE: The default is for Ethernet II packets.
{permit | deny | redirect-to interface} tagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]] [time-range
time-range-name]
no {permit | deny | redirect-to interface} tagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{permit | deny | redirect-to interface} untagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype protocol [protocol-bitmask]]
[time-range time-range-name]
no {permit | deny | redirect-to interface} untagged-eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[ethertype protocol [protocol-bitmask]]
{permit | deny | redirect-to interface} tagged-802.3
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [time-range time-range-name]
Chapter 26: Access Control Lists
26-19