Chapter 35 Vlan Commands - Supermicro SSE-G2252 User Manual

A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Command Group
GVRP and Bridge Extension
Commands
Editing VLAN Groups
Configuring VLAN Interfaces
Displaying VLAN Information
Configuring IEEE 802.1Q
Tunneling
Configuring Port-based Traffic
Segmentation
Configuring Protocol-based
VLANs
Configuring IP Subnet VLANs
Configuring MAC Based VLANs
Configuring Voice VLANs
Chapter 35
VLAN Commands
Table 35-1. VLAN Commands
Function
Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
Sets up VLAN groups, including name, VID and state
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members, and MAC addresses
Configures 802.1Q Tunneling (QinQ Tunneling)
Configures traffic segmentation for different client sessions based on
specified downlink and uplink ports
Configures protocol-based VLANs based on frame type and protocol
Configures IP Subnet-based VLANs
Configures MAC-based VLANs
Configures VoIP traffic detection and enables a Voice VLAN
Chapter 35: VLAN Commands
35-1