Command Mode
Global Configuration
Command Usage
•
This parameter only applies to SNMP applications which use data stored in the
LLDP MIB for network monitoring or management.
•
Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a
notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect any
lldpRemTablesChange notification-events missed due to throttling or transmission
loss.
Example
SSE-G2252(config)#lldp notification-interval 30
SSE-G2252(config)#
lldp refresh-interval
This command configures the periodic transmit interval for LLDP advertisements. Use
the no form to restore the default setting.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are sent.
(Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Example
SSE-G2252(config)#lldp refresh-interval 60
SSE-G2252(config)#
Chapter 39: LLDP Commands
39-5