Set Cos - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual
• The trTCM can be used to mark a IP packet stream in a service, where different,
decreasing levels of assurances (either absolute or relative) are given to packets
which are green, yellow, or red. Refer to RFC 2698 for more information on other
aspects of trTCM.
Example
This example creates a policy called "rd-policy," uses the
previously defined "rd-class," uses the
incoming packets will receive, and then uses the police trtcm-color-blind command to
limit the average bandwidth to 100,000 Kbps, the committed burst rate to 4000 bytes,
the peak information rate to 1,000,000 kbps, the peak burst size to 6000, to remark any
packets exceeding the committed burst size, and to drop any packets exceeding the
peak information rate.
SSE-G2252(config)#policy-map rd-policy
SSE-G2252(config-pmap)#class rd-class
SSE-G2252(config-pmap-c)#set phb 3
SSE-G2252(config-pmap-c)#police trtcm-color-blind 100000 4000 100000 6000
conform-action transmit exceed-action 0 violate-action drop
SSE-G2252(config-pmap-c)#

set cos

This command modifies the class of service (CoS) value for a matching packet (as
specified by the
this setting.
Syntax
[no] set cos cos-value
cos-value - Class of Service value. (Range: 0-7)
Default Setting
None
Command Mode
Policy Map Class Configuration
Command Usage
• The set cos command is used to set the CoS value in the VLAN tag for matching
packets.
• The set cos and
setting either of these commands will overwrite any action already configured by the
other command.
match command) in the packet's VLAN tag. Use the no form to remove
set phb command function at the same level of priority. Therefore
class
set phb command to classify the service that
37-14
command to specify the