Supermicro SSE-G2252 User Manual page 304

SSE-G2252/SSE-G2252P Switches User's Manual
• Max MAC Count
authenticated on a port via MAC authentication; that is, the Network Access
process described in this section. (Range: 1-1024; Default: 1024)
• Network Access Max MAC Count
addresses that can be authenticated on a port interface via all forms of
authentication (including Network Access and IEEE 802.1X). (Range: 1-1024;
Default: 1024)
• Guest VLAN – Specifies the VLAN to be assigned to the port when 802.1X
Authentication fails. (Range: 0-4093, where 0 means disabled; Default: Disabled)
The VLAN must already be created and active (see
page 7-4). Also, when used with 802.1X authentication, intrusion action must be set
for "Guest VLAN" (see
• Dynamic VLAN – Enables dynamic VLAN assignment for an authenticated port.
When enabled, any VLAN identifiers returned by the RADIUS server through the
802.1X authentication process are applied to the port, providing the VLANs have
already been created on the switch. (GVRP is not used to create the VLANs.)
(Default: Enabled)
The VLAN settings specified by the first authenticated MAC address are
implemented for a port. Other authenticated MAC addresses on the port must have
the same VLAN configuration, or they are treated as authentication failures.
If dynamic VLAN assignment is enabled on a port and the RADIUS server returns
no VLAN configuration (to the 802.1X authentication process), the authentication is
still treated as a success, and the host is assigned to the default untagged VLAN.
When the dynamic VLAN assignment status is changed on a port, all authenticated
addresses mapped to that port are cleared from the secure MAC address table.
• Dynamic QoS – Enables dynamic QoS assignment for an authenticated port.
(Default: Disabled)
• MAC Filter ID – Allows a MAC Filter to be assigned to the port. MAC addresses or
MAC address ranges present in a selected MAC Filter are exempt from
authentication on the specified port (as described under
Address Filter"). (Range: 1-64; Default: None)
Web Interface
To configure MAC authentication on switch ports:
1. Click S
ECURITY
2. Select C
ONFIGURE
1. The maximum number of MAC addresses per port is 1024, and the maximum
number of secure MAC addresses supported for the switch system is 1024. When
the limit is reached, all new MAC addresses are treated as authentication failures.
1
– Sets the maximum number of MAC addresses that can be
"Configuring Port Authenticator Settings for
> N A
ETWORK CCESS
I from the Step list.
NTERFACE
5
– Sets the maximum number of MAC
"Configuring VLAN Groups" on
.
14-26
802.1X").
"Configuring a MAC