Access-List Ip - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

access-list ip

This command adds an IP access list and enters configuration mode for standard or
extended IPv4 ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} acl-name
standard – Specifies an ACL that filters packets based on the source IP address.
extended – Specifies an ACL that filters packets based on the source or destination
IP address, and other more specific criteria.
acl-name – Name of the ACL. (Maximum length: 32 characters, no spaces or other
special characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL, use
the permit or deny command to add new rules to the bottom of the list.
• To remove a rule, use the no permit or no deny command followed by the exact
text of a previously configured rule.
• An ACL can contain up to 128 rules.
Example
SSE-G2252(config)#access-list ip standard david
SSE-G2252(config-std-acl)#
Related Commands
"permit, deny, redirect-to (Standard IP ACL)" on page 26-3
"ip access-group" on page 26-8
"show ip access-group" on page 26-8
26-2