Ipv6 Dhcp Restart Client Vlan - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

ipv6 dhcp restart client vlan

This command submits a DHCPv6 client request.
Syntax
ipv6 dhcp restart client vlan vlan-id
vlan-id - VLAN ID, specified as a single number, a range of consecutive numbers
separated by a hyphen, or multiple numbers separated by commas. (Range:
1-4093, no leading zeroes)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• This command starts the DHCPv6 client process if it is not yet running by submitting
requests for address prefix delegation through the specified interface(s).
• When the DHCP client process is enabled and a prefix is successfully acquired, the
prefix is stored in the IPv6 general prefix pool. Other commands and applications
(such as the
prefix pool.
• DHCPv6 clients can also request configuration parameters that do not require a
server to maintain any dynamic state for individual clients, such as DNS server
addresses.
• DHCPv6 clients builds a list of servers by sending a solicit message and collecting
advertised message replies. These servers are then ranked based on their
advertised preference value. If the client needs to acquire prefixes from servers,
only servers that have advertised prefixes are considered.
Example
The following command submits a client request on VLAN 1.
SSE-G2252#ipv6 dhcp restart client vlan 1
SSE-G2252#
Related Commands
"ipv6 address" on page 42-13
ipv6 address command) can then refer to the prefixes in the general
41-4