Auto-Traffic-Control Alarm-Clear-Threshold - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual

auto-traffic-control alarm-clear-threshold

This command sets the lower threshold for ingress traffic beneath which a control
response for rate limiting will be released after the Release Timer expires, if so
configured by the
restore the default setting.
Syntax
auto-traffic-control {broadcast | multicast}
alarm-clear-threshold threshold
no auto-traffic-control {broadcast | multicast}
alarm-clear-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The lower threshold for ingress traffic beneath which a cleared storm
control trap is sent. (Range: 1-255 kilo-packets per second)
Default Setting
128 kilo-packets per second
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Once the traffic rate falls beneath the lower threshold, a trap message may be sent
if configured by the
command or
• If rate limiting has been configured as a control response, it will be discontinued
after the traffic rate has fallen beneath the lower threshold, and the release timer
has expired. Note that if a port has been shut down by a control response, it will not
be re-enabled by automatic traffic control. It can only be manually re-enabled using
the auto-traffic-control control-release
Example
This example sets the clear threshold for automatic storm control for broadcast traffic on
port 1.
SSE-G2252(config)#interface ethernet 1/1
SSE-G2252(config-if)#auto-traffic-control broadcast alarm-clear-threshold
155
SSE-G2252(config-if)#
auto-traffic-control auto-control-release
snmp-server enable port-traps atc broadcast-alarm-clear
snmp-server enable port-traps atc multicast-alarm-clear
command. Use the no form to
command.
32-6
command.