Auto-Traffic-Control Apply-Timer - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual
Command
snmp-server enable port-traps
atc multicast-control-apply
snmp-server enable port-traps
atc multicast-control-release
ATC Display Commands
show auto-traffic-control
show auto-traffic-control interface
a. Enabling automatic storm control on a port will disable hardware-level storm
control on the same port if configured by the

auto-traffic-control apply-timer

This command sets the time at which to apply the control response after ingress traffic
has exceeded the upper threshold. Use the no form to restore the default setting.
Syntax
auto-traffic-control {broadcast | multicast} apply-timer seconds
no auto-traffic-control {broadcast | multicast} apply-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The interval after the upper threshold has been exceeded at which to
apply the control response. (Range: 1-300 seconds)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
After the apply timer expires, a control action may be triggered as specified by the
auto-traffic-control action
snmp-server enable port-traps atc broadcast-control-apply
enable port-traps atc multicast-control-apply
Table 32-1. ATC Commands (Continued)
Function
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
Sends a trap when multicast traffic falls beneath the
lower threshold after a storm control response has been
triggered and the release timer expires
Shows global configuration settings for automatic storm
control
Shows interface configuration settings and storm control
status for the specified port
command and a trap message sent as specified by the
switchport packet-rate
command.
32-2
command.
command or snmp-server
Mode
IC (Port)
IC (Port)
PE
PE