Ipv6 Address Autoconfig - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual
Example
This example specifies a full IPv6 address and prefix length.
SSE-G2252(config)#interface vlan 1
SSE-G2252(config-if)#ipv6 address 2001:DB8:2222:7272::72/96
SSE-G2252(config-if)#end
SSE-G2252#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
FE80::2E0:CFF:FE00:FD/64
Global unicast address(es):
2001:DB8:2222:7272::72/96, subnet is 2001:DB8:2222:7272::/96
Joined group address(es):
FF02::1:FF00:72
FF02::1:FF00:FD
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
SSE-G2252#
Related Commands
"ipv6 address eui-64" on page 42-16
"ipv6 address autoconfig" on page 42-14
"show ipv6 interface" on page 42-21
"ip address" on page 42-2

ipv6 address autoconfig

This command enables stateless autoconfiguration of IPv6 addresses on an interface
and enables IPv6 on the interface. The network portion of the address is based on
prefixes received in IPv6 router advertisement messages; the host portion in based on
the modified EUI-64 form of the interface identifier (i.e., the switch's MAC address). Use
the no form to remove the address generated by this command.
Syntax
[no] ipv6 address autoconfig
Default Setting
No IPv6 addresses are defined
Command Mode
Interface Configuration (VLAN)
42-14