Supermicro SSE-G2252 User Manual page 867

delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a specific
VLAN. Use this command to add static addresses to the MAC Address Table. Static
addresses have the following characteristics:
• Static addresses will not be removed from the address table when a given interface
link is down.
• Static addresses are bound to the assigned interface and will not be moved. When a
static address is seen on another interface, the address will be ignored and will not
be written to the address table.
• A static address cannot be learned on another port until the address is removed with
the no form of this command.
Example
SSE-G2252(config)#mac-address-table static 00-e0-29-94-34-de interface
ethernet 1/1 vlan 1 delete-on-reset
SSE-G2252(config)#
Chapter 33: Address Table Commands
33-3