Supermicro SSE-G2252 User Manual page 839

uplink - A port configured to receive or transmit remotely mirrored traffic.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-52)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Only 802.1Q trunk or hybrid (i.e., general use) ports can be configured as an
RSPAN uplink port – access ports are not allowed (see
• Only one uplink port can be configured on a source switch, but there is no limitation
on the number of uplink ports configured on an intermediate or destination switch.
• Only destination and uplink ports will be assigned by the switch as members of this
VLAN. Ports cannot be manually assigned to an RSPAN VLAN with the
allowed vlan command. Nor can GVRP dynamically add port members to an
RSPAN VLAN. Also, note that the
members for an RSPAN VLAN, but will only show configured RSPAN VLAN
identifiers.
Example
The following example enables RSPAN on VLAN 2, specifies this device as an RSPAN
destination switch, and the uplink interface as port 3:
SSE-G2252(config)#rspan session 1 remote vlan 2 destination
uplink ethernet 1/3
SSE-G2252(config)#
Chapter 30: Port Mirroring Commands
show vlan command will not display any
30-9
switchport mode).
switchport