SSE-G2252/SSE-G2252P Switches User's Manual
Command
access-list arp
permit, deny (ARP ACL)
show arp access-list
access-list arp
This command adds an ARP access list and enters ARP ACL configuration mode. Use
the no form to remove the specified ACL.
Syntax
[no] access-list arp acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
•
When you create a new ACL or enter configuration mode for an existing ACL, use
the permit or deny command to add new rules to the bottom of the list. To create an
ACL, you must add at least one rule to the list.
•
To remove a rule, use the no permit or no deny command followed by the exact
text of a previously configured rule.
•
An ACL can contain up to 128 rules.
Example
SSE-G2252(config)#access-list arp factory
SSE-G2252(config-arp-acl)#
Related Commands
"permit, deny (ARP ACL)" on page 26-25
"show arp access-list" on page 26-26
Table 26-6. ARP ACL Commands
Function
Creates a ARP ACL and enters configuration mode
Filters packets matching a specified source or destination
address in ARP messages
Displays the rules for configured ARP ACLs
26-24
Mode
GC
ARP-ACL
PE