power inline
This command instructs the switch to automatically detect if a PoE-compliant device is
connected to the specified port, and turn power on or off accordingly. Use the no form to
turn off power for a port, or the no form with the time-range keyword to remove the time
range settings.
Syntax
power inline [time-range time-range-name]
no power inline [time-range]
time-range-name - Name of the time range.
(Range: 1-30 characters)
Default Setting
Detection is enabled for PoE-compliant devices.
Command Mode
Interface Configuration (Ethernet ports 1-48)
Command Usage
•
The switch only provides power to the Fast Ethernet or Gigabit Ethernet
copper-media ports.
•
When detection is enabled for PoE-compliant devices, power is automatically
supplied when a device is detected on the port, providing that the power demanded
does not exceed the port's power budget or the switch's power budget.
Example
SSE-G2252P(config)#interface ethernet 1/1
SSE-G2252P(config-if)#power inline
SSE-G2252P(config-if)#exit
SSE-G2252P(config)#interface ethernet 1/2
SSE-G2252P(config-if)#no power inline
SSE-G2252P(config-if)#
Related Commands
"time-range" on page 21-60
Chapter 29: Power Over Ethernet Commands
29-3