Ipv6 Interface - Supermicro SSE-G2252 User Manual

42-2 IPv6 Interface

This switch supports the following IPv6 interface commands.
Command
Interface Address Configuration and Utilities
ipv6 default-gateway
ipv6 address
ipv6 address autoconfig
ipv6 address eui-64
ipv6 address link-local
ipv6 enable
show ipv6 default-gateway
show ipv6 interface
show ipv6 traffic
clear ipv6 traffic
ping6
Neighbor Discovery
clear ipv6 neighbors
show ipv6 neighbors
Table 42-5. IPv6 Configuration Commands
Function
Sets an IPv6 default gateway for traffic
Configures an IPv6 global unicast address, and enables
IPv6 on an interface
Enables automatic configuration of IPv6 global unicast
addresses on an interface and enables IPv6 on the
interface
Configures an IPv6 global unicast address for an
interface using an EUI-64 interface ID in the low order 64
bits, and enables IPv6 on the interface
Configures an IPv6 link-local address for an interface and
enables IPv6 on the interface
Enables IPv6 on an interface that has not been
configured with an explicit IPv6 address
Displays the current IPv6 default gateway
Displays the usability and configured settings for IPv6
interfaces
Displays statistics about IPv6 traffic
Resets IPv6 traffic counters
Sends IPv6 ICMP echo request packets to another node
on the network
Deletes all dynamic entries in the IPv6 neighbor
discovery cache
Displays information in the IPv6 neighbor discovery
cache
Chapter 42: IP Interface Commands
42-11
Mode
GC
IC
IC
IC
IC
IC
NE, PE
NE, PE
NE, PE
PE
PE
PE
PE