Supermicro SSE-G2252 User Manual page 346

SSE-G2252/SSE-G2252P Switches User's Manual
• If anyone tries to access a management interface on the switch from an invalid
address, the switch will reject the connection, enter an event message in the system
log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access respectively. Each
of these groups can include up to five different sets of addresses, either individual
addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the switch
will not accept overlapping address ranges. When entering addresses for different
groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete the
entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
These parameters are displayed in the web interface:
• Mode
• Web – Configures IP address(es) for the web group.
• SNMP – Configures IP address(es) for the SNMP group.
• Telnet – Configures IP address(es) for the Telnet group.
• Start IP Address – A single IP address, or the starting address of a range.
• End IP Address – The end address of a range.
Web Interface
To create a list of IP addresses authorized for management access:
1. Click S
ECURITY
2. Select A
DD
3. Select the management interface to filter (W
4. Enter the IP addresses or range of addresses that are allowed management access
to an interface.
5. Click A
PPLY
Parameters
> IP F .
ILTER
from the Action list.
, SNMP, T
EB
14-68
).
ELNET