service-policy
This command applies a policy map defined by the policy-map command to the ingress
side of a particular interface. Use the no form to remove this mapping.
Syntax
[no] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
•
Only one policy map can be assigned to an interface.
•
First define a class map, then define a policy map, and finally use the
service-policy command to bind the policy map to the required interface.
•
The switch does not allow a policy map to be bound to an interface for egress traffic.
Example
This example applies a service policy to an ingress interface.
SSE-G2252(config)#interface ethernet 1/1
SSE-G2252(config-if)#service-policy input rd-policy
SSE-G2252(config-if)#
Chapter 37: Quality of Service Commands
37-17