Snmp-Server Enable Port-Traps Atc Multicast-Alarm-Clear - Supermicro SSE-G2252 User Manual

SSE-G2252/SSE-G2252P Switches User's Manual
snmp-server enable port-traps atc
multicast-alarm-clear
This command sends a trap when multicast traffic falls beneath the lower threshold after
a storm control response has been triggered. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc multicast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
SSE-G2252(config)#interface ethernet 1/1
SSE-G2252(config-if)#snmp-server enable port-traps atc
multicast-alarm-clear
SSE-G2252(config-if)#
Related Commands
"auto-traffic-control action" on page 32-4
"auto-traffic-control alarm-clear-threshold" on page 32-6
32-14