garp timer
This command sets the values for the join, leave and leaveall timers. Use the no form to
restore the timers' default values.
Syntax
garp timer {join | leave | leaveall} timer-value
no garp timer {join | leave | leaveall}
{join | leave | leaveall} - Timer to set.
timer-value - Value of timer. Ranges: join: 20-1000 centiseconds; leave: 60-3000
centiseconds; leaveall: 500-18000 centiseconds
Default Setting
join: 20 centiseconds
leave: 60 centiseconds
leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
•
Group Address Registration Protocol is used by GVRP and GMRP to register or
deregister client attributes for client services within a bridged LAN. The default
values for the GARP timers are independent of the media access method or data
rate. These values should not be changed unless you are experiencing difficulties
with GMRP or GVRP registration/deregistration.
•
Timer values are applied to GVRP for all the ports on all VLANs.
•
Timer values must meet the following restrictions:
•
leave >= (2 x join)
•
leaveall > leave
NOTE: Set GVRP timers on all Layer 2 devices connected in the same network
to the same values. Otherwise, GVRP may not operate successfully.
Example
SSE-G2252(config)#interface ethernet 1/1
SSE-G2252(config-if)#garp timer join 100
SSE-G2252(config-if)#
Chapter 35: VLAN Commands
35-3