Supermicro SSE-G2252 User Manual page 274

SSE-G2252/SSE-G2252P Switches User's Manual
Command Usage
All ports are set to VLAN access mode by default. Prior to enabling VoIP for a port (by
setting the VoIP mode to Auto or Manual as described below), first set the VLAN
membership mode to hybrid (see
Parameters
These parameters are displayed in the web interface:
• Auto Detection Status – Enables the automatic detection of VoIP traffic on switch
ports. (Default: Disabled)
• Voice VLAN – Sets the Voice VLAN ID for the network. Only one Voice VLAN is
supported and it must already be created on the switch. (Range: 1-4093)
• Voice VLAN Aging Time – The time after which a port is removed from the Voice
VLAN when VoIP traffic is no longer received on the port. (Range: 5-43200
minutes; Default: 1440 minutes)
NOTE: The Voice VLAN ID cannot be modified when the global Auto Detection
Status is enabled.
Web Interface
To configure global settings for a Voice VLAN:
1. Click T
RAFFIC
2. Select C
ONFIGURE
3. Enable A
UTO
4. Specify the V
5. Adjust the V
6. Click A
PPLY
"Adding Static Members to VLANs" on page
> V IP.
O
G from the Step list.
LOBAL
D .
ETECTION
VLAN ID.
OICE
VLAN A T
OICE GING
.
Figure 13-1. Configuring a Voice VLAN
if required.
IME
13-2
7-6).