Create Protocol - Extreme Networks ExtremeWare Command Reference Manual

VLAN Commands

create protocol

create protocol <protocol_name>
Description
Creates a user-defined protocol filter.
NOTE
This command is available only on the "i" series switches and the Summit 400 series switches.
Syntax Description
protocol_name Specifies a protocol filter name. The protocol filter name can have a maximum of
31 characters.
Usage Guidelines
Protocol-based VLANs enable you to define packet filters that the switch can use as the matching
criteria to determine if a particular packet belongs to a particular VLAN.
After you create the protocol, you must configure it using the
assign it to a VLAN, use the
Example
The following command creates a protocol named fred:
create protocol fred
History
This command was first available in ExtremeWare 1.0.
This command was added to the Summit 400-48t switch in ExtremeWare 7.2e.
Platform Availability
This command is available on the "i" series platforms and the Summit 400 series switches.
390
configure vlan protocol
configure protocol add
command.
command. To
ExtremeWare 7.7 Command Reference Guide