Extreme Networks ExtremeWare XOS Command Reference Manual page 654

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Status Monitoring and Statistics
If you enable sFlow globally on the switch and on original I/O module ports and you try to enable
●
mirroring on original, a-series, or e-series I/O module ports, the switch displays a message similar to
the following:
Error: Mirroring is not compatible with SFlow. Mirroring not enabled!
Configuration failed on backup MSM, command execution aborted!
If you see the above message, you must disable sFlow on all of the original I/O module ports.
If you enable sFlow globally on the switch and on a-series or e-series I/O module ports and you try
●
to enable mirroring on original I/O module ports, the switch does not display an error. You can
successfully enable mirroring on original I/O module ports, provided you do not enable sFlow on
original I/O module ports.
If you enable sFlow on original I/O module ports, sFlow uses QP2 to sample traffic. When enabling
●
sFlow on those ports, the switch displays a message similar to the following:
SFLOW will use Qos Profile QP2.
For more information about the BlackDiamond 8800 a-series, e-series modules, and original modules see
Chapter 1, "ExtremeWare XOS Overview"
Networks Consolidated ExtremeWare XOS Hardware Guide. For more information about mirroring, see
Chapter 5, "Configuring Slots and Ports on a Switch"
information about QOS, see
Example
The following command enables sFlow sampling on the port 3:1:
enable sflow ports 3:1
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms with an Advanced Edge, a Core, or an Advanced Core
license.
654
in the ExtremeWare XOS Concepts Guide and the Extreme
Chapter 16, "Quality of Service"
in the ExtremeWare XOS Concepts Guide. For more
in the ExtremeWare XOS Concepts Guide.
ExtremeWare XOS 11.5 Command Reference Guide