Configuring Islb Initiator Names Or Ip Addresses - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•
•
•

Configuring iSLB Initiator Names or IP Addresses

You must specify the iSLB initiator name or IP address before configuring it.
Specifying the iSLB initiator name or IP address is the same as for an iSCSI initiator. See the
Note
Mapping" section on page
To enter iSLB initiator configuration submode using the name option for an iSLB initiator, follow these
steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# islb initiator name
iqn.1987-02.com.cisco.initiator
switch(config-islb-init)#
switch(config)# no lslb initiator name
iqn.1987-02.com.cisco.initiator
To enter iSLB initiator configuration submode using the ip-address option for an iSLB initiator, follow
these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# islb initiator
ip-address 10.1.1.3
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 10.1.1.3
switch(config)# islb initiator
ip-address 2001:0DB8:800:200C::417A
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 2001:0DB8:800:200C::417A
Cisco MDS 9000 Family CLI Configuration Guide
43-42
Making the Dynamic iSLB Initiator WWN Mapping Static, page 43-43
Assigning VSAN Membership for iSLB Initiators, page 43-44
Configuring Metric for Load Balancing, page 43-45
Verifying iSLB Initiator Configuration, page 43-45
Verifying iSLB Authentication Configuration, page 43-49
Configuring and Activating Zones for iSLB Initiators and Initiator Targets, page 43-46
Configuring iSLB Session Authentication, page 43-48
Verifying iSLB Authentication Configuration, page 43-49
43-13.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the iSCSI name of
the initiator node (iqn.1987-02.com.cisco.initiator) and
enters iSLB initiator configuration submode. The
maximum name length is 223 alphanumeric characters.
The minimum length is 16.
Deletes the configured iSLB initiator.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the IPv4 address of
the initiator node and enters iSLB initiator configuration
submode.
Deletes the configured iSLB initiator.
Configures an iSLB initiator using the IPv6 unicast
address of the initiator node and enters iSLB initiator
configuration submode.
Deletes the configured iSLB initiator.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 43 Configuring iSCSI
"Static