Reading A Ras System Message - Brocade Communications Systems 8 Reference

1

Reading a RAS System Message

2. Verify the configuration:
3. Enable the audit feature:
4. Configure up to six syslog servers to receive the audit events that will be generated through
5. Configure syslog on the switch to point to the configured servers' IP addresses.
6. Verify the switch's syslog configuration:
Reading a RAS System Message
This section provides information about reading system messages.
The following example shows the format of the RAS system error message:
The following example shows a sample message from the error log:
2009/02/10-14:18:04, [SS-1000], 88, SLOT 6 | FFDC | CHASSIS, INFO, ESNSVT_DCX,
supportSave has uploaded support information to the host with IP address
168.159.16.128
2009/02/10-14:13:34, [SS-1001], 87, SLOT 6/1 | FFDC | CHASSIS, WARNING,
ESNSVT_DCX, supportSave's upload operation to host IP address aborted
2009/02/10-15:44:51, [SEC-1203], 89, SLOT 6 | FFDC | FID 128, INFO, ESNSVT_DCX,
Login information: Login successful via TELNET/SSH/RSH. IP Addr:168.159.16.128
The fields in the error message are described in
TABLE 3
Example
2004/07/22-10:12:33 Date and Time
8
switch:admin> auditcfg --show
Audit filter is enabled.
1-ZONE
2-SECURITY
3-CONFIGURATION
4-FIRMWARE
5-FABRIC
switch:admin> auditcfg --enable
Audit filter is enabled.
syslog (procedure will vary depending on server type).
switch:admin> syslogdipadd 10.128.128.160
switch:admin> syslogdipshow
syslog.1 192.168.163.234
syslog.2 10.128.128.160
<timestamp>, [<Event ID>], <Sequence Number>, <Flags>,<Severity>,<Switch
name>, <Event-specific information>
System Message Field Description
Variable Name
Stamp
Table 3.:
Description
The system time (UTC) when the message was generated on the
switch. The RASLog subsystem supports an internationalized
timestamp format base on the "LOCAL" setting.
Fabric OS Message Reference
53-1001767-01